Xtramus APMPT-4 V2.4 Manual de usuario descargar pdf (Pagina 54)

E-mail: sales@xtramus.com

Website: www.Xtramus.com

XTRAMUS TECHNOLOGIES

5.2. Test Tasks – Layer 2

All settings regarding to Layer 2 tasks can be set here. For available Layer 2 tasks and their descriptions,

please refer to “1.3.2. Performance Task in Layer 2 (PT2).”

5.2.1. Port Map

 Port Select …: By clicking this button, a Select Ports for Testing window will pop up, allowing you

to select the module cards and the ports you would like to use for the task.

 IP Setup …: For layer2 tasks, the IP Setup button presents gray, which serves no function under

here.

 Source/Destination Port: These two fields display the source/ destination port for the task. Ports

are displayed in IDs in the format of (X, Y, Z) while X is the number of the chassis (which is displayed

on NuStreams-2000i/600i), Y is the slot number where this model card is installed, and Z is the

available port number located on the model card.

 Port Map: This field shows how test streams will be transmitted from port to port.

 : To assign how test streams flow from source port to the destination port, click a port from Source

Port, click a port from Destination Port, and then click  button to add them to the Port Map.

 : To remove a port map setting from Port Map, click the setting you would like to remove, and then

click  button to remove it from Port Map.

 Pair >: APMPT-4 will match ports located on the same module card in a back-and-forth manner, and

add them to the Port Map.

 Rotate >: APMPT-4 will match ports so the last port will connect to the first port, thus forming a loop.

If you have the same amount of ports on your chassis and DUT, Rotate allows you to test all DUT‟s

ports simultaneously.

 Reset <: Reset all port map settings in the Port Map.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 144 145

Sin comentarios

Xtramus APMPT-4 V2.4 Manual de usuario Pagina 54